Adam Scott visits the Tour Van

Posted: June 12, 2007

Titleist ambassador Adam Scott visited the Tour van last week in Memphis to pick up a new PT 906F2 fairway in preparation for this week's U.S. Open. Adam posted his second top ten finish over the past two weeks at the Stanford St. Jude Championship and the Memorial Tournament. He'll look to keep that momentum going when he tees it up Thursday at Oakmont Country Club in suburban Pittsburgh.


Adam takes a break inside the Titleist Tour Van.


The work order for Adam's new PT 906F2 fairway.

Please login to post a comment

Haven't registered for Team Titleist yet? Click here to create your account.

Evman1023


Is this Adam's 3-wood or is this his 5-wood?

Evman1023


How is a club bent to manipulate loft?

Evman1023


Right, that's what I was referring to. I usually just say my 15° and 18°. Thanks.

Evman1023


We typically refer to our fairways by their loft. The 16.5° <a href="www.titleist.com/.../906f2.asp" rel="nofollow">PT 906F2</a> was the only fairway Adam carried last week at the Stanford St. Jude Championship

Evman1023


See the first photo <a href="/2007/03/21/rick-nelson-with-adam-scott/" rel="nofollow">here</a>.

Evman1023


I notice that on Adam's Tour Van Work Order it says shaft: NV Blue By You 95. Is this shaft a blue Aldila NV or is it an Aldila VS Proto? Also, is Adam's shaft the same as a person could buy at retail?   Thanks.

Evman1023


I see that you bent Adam's fairway from 18° to 16.5°.  My question is, is the PT 906F2 easier to bend than most other fairways or is it just as hard/uncommon to do?  I have always heard that it's hard or not common to bend or manipulate the lofts on fairways.  And lastly, can you comment on why Adam chose to bend an 18° instead of a 15°? Does it have anything to do with lie angle or setup/leading edge to the ground?

Evman1023


It's the Aldila VS Proto 95 Fairway shaft, which is the same shaft a consumer can get at a golf shop.

Evman1023


I noticed that under the "flex" heading, the work order read: "same tipping as 3-wood".  How much is Adam's 3-wood tipped?  Also, are his irons, hybrid, or driver tipped at all?

In addition, what are Adam's typical launch conditions with a driver?

Evman1023


Can you bend a driver a degree stronger without affecting its lie or face setup? I'm thinking about doing it to my 983K, from 11.5° to 10.5°.