Length of AP2 shafts...not playing lengths, shafts only

Started by : Don D |

Jump To Last Reply

Don D


I am looking at installing a set of shafts into my 712 AP2s, and these shafts were pulled from another set of irons.  What I want to know is how much longer will the playing length be over the length of the uninstalled shafts?  I know the standard playing length of the clubs as listed on the website...what I want to know is how much to I need to add to the length of the uninstalled shafts to determine what the playing length will be?

Don D


In other words, I am looking for the "bottom of bore to ground" measurement...and I assume it's consistent throughout the set (I have 4-PW)?

Don O


Might be a moot point if the shafts are different diameters than wha Titleist can accept.

Don D


Thanks, but it's not a moot point, the shafts are .355 taper tip, which is what the 712 AP2s take.  I just need to know the bottom of bore to ground measurement.

Don D


So, nobody had any idea what the bottom of bore to ground measurement is on the AP2 712?

Ken W


Don, Just add 1.25 inches to the raw shaft length and that will be an extremely close approximation. Don't forget 1/8 of an inch is factored into the final length for the grip cap i.e. a 38 inch five iron is cut to 37 7/8 before grip installation.

Don D


Thanks, Ken!