714 AP2 Shaft Change

Follow Thread

By Tom G

  • 0 Likes
  • 2 Replies
  1. Tom G

    Tom G
    South Pasadena, CA

    I purchased a set of AP2 714's that had the Titleist Adila Graphite shafts and now I want to change them/Reshaft them to Steel. I pulled the graphites fine - but it appears the Dynalite Gold XP shaft which is .355 is too loose. When I try a KBS Tour 90 which is .370 it won't fit!  Help please!

  2. Cameron D

    Cameron D
    Newport, RI

    Tom, 

    The .355 taper tip should fit perfectly as that is the tip diameter for our irons.

    Cameron

    1-888-TITLEIST

  3. Ruben A

    Ruben A
    Atlanta, GA

    The .355 shaft is definitely the right shaft.  Check inside the hosel to make sure there isn't any leftover epoxy in there that would prevent the club from seating properly.  If the hosel is clean, you can use glass beads to thicken the epoxy a bit.  That will help remove any play between the shaft and epoxy.

    Good luck..

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up