Today I hit an AP2 demo 6 iron, and I want to look into buying a set CB's. I just need to know the specs of the iron I hit today and if there is any changes because of going from the AP2 to the CB. What i know from the club was that it was a stiff shaft X300 and +1/2" on them. Which is needed. The only thing I need to know is what the numbers on the back side of the hosel meant, it was a +2 over a horizontal line and below the line was STD. Would be a great help if I could get the right specs for these irons
Note: I did hit the AP2 off of a strike board five times and each time the tape was contacted in the middle.
Jersey,
The CB and AP2 will have the same lofts, lie, and lengths at standard. There should have been an arrow pointing to either "STD" or "+2". This indicates the lie angle, either standard or 2* upright.
Cameron
1-888-TITLEIST
There was no arrow indicating the standard or +2, but the guy in the pro shop said it was standard