Re: Shaft Question with the 913 D2

John L — Sun, 25 Nov 2012 04:50:24 GMT

We'll i'll take a stab in the dark at it but honistly you should always get fitted. First off it would be a lot better to know what your previous shaft and club specs are. The Fubuki is a slightly higher launch than the stock blue board. I would say with your swing speed getting the ball up really wont be a problem. I would go with the stock blue board and save the money. Especially if your not going to go threw the fitting process. This years stock offerings seem to be slightly stiffer than the 910 lines. Going from Stiff to X-stiff wont increase yards but will probably ad a little bit of shot consistency. This is assuming you make consistant swings and ball contact.

Re: Shaft Question with the 913 D2

Steve S — Sat, 24 Nov 2012 19:29:50 GMT

Kinda of a difficult question to answer on a forum. The two shafts you're looking at are pretty different if I'm not mistaken. What I'd suggest is getting fit when you buy your new driver. I like to test out a few shafts without worrying about the launch monitor numbers just to see what FEELS the best. Once you narrow it down to a your favorite two or three FEELING shafts, then start using the launch monitors to see which ones get you the best numbers for launch angle and spin rates. Do this and you may end up with a shaft you didn't expect.