May 20, 2013 By Parker F
May 22, 2013 at 7:03pm
Titleist only makes a 2 iron in the CB line. If you want a muscleback, you will have to go back to a previous model like the 690 or 695. It will most likely be pre-owned so you will have to buy it and have it adjusted to match your set. The fact that it is an older model does not mean it doesn't conform to the USGA groove rule. That only applies to clubs with 24 or more degrees of loft.
May 22, 2013 at 9:12pm
I use a 695 CB 2 iron with my AP2 712s. Good results.
May 23, 2013 at 8:28am
The closest you will get is the 712U. You can order it as a 2 iron loft and add your particular custom shaft and specs. And it may be a bit easier to hit than a normal 2 iron.
May 23, 2013 at 9:35am
I would give the new 712U a shot. I tried them out a week or so ago and they have a 2, 3, and 4 iron in the 712U. They very much resemble the MB, but are a bit thinker on the bottom. Great club to try.
May 23, 2013 at 12:57pm
You should look into the new 712U. It has been well received and should blend in perfect with your mb's.
May 23, 2013 at 3:14pm
Trust me get the 712U, you will not regret it. I have the 910F 18 degree and just picked up my 712U and its so much easier to hit.
Haven't registered for Team Titleist yet?