Yes.

The iron standard length specifications are the same on the 716 AP1s, AP2s, CB forged, and MB forged.


3 - 39.00"
4 - 38.50"
5 - 38.00"
6 - 37.50"
7 - 37.00"
8 - 36.50"
9 - 36.00"
P - 35.75"
W - 35.50"

*** For future reference, information regarding clubs is available on this side. Click on clubs above. If you cannot find the club, then click on other club then type in the model then type (iron, driver, etc.) and it will give you the specs on most clubs manufactured by Titleist. I find it most helpful.

Are these shaft lengths, raw lengths, shaft only, or are they with the head attached and included?

When shaft lengths are normally given, are they given minus the head, thus the shaft raw length, or always with the head attached?

Many thanks,
Richard

yes as there is no bore through on either of those clubs

Standard length,yes,if that's your titleist fitting recommendation.

Can I just ask, in relation to shaft lengths when quoted, are they raw lengths (shaft only), or are they including the head as well?

Many thanks,
Richard

The shaft length is for the assembled club before gripping- the length is measured from the butt to the point on the ground the shaft would meet if it were entended to that point. The length with the grip on would be an additional 1/8" to 1/4" to account for the grip cap. The length from the bottom of the hosel to the ground is called the "BBGM"- Bottom of the Bore to the Ground Measurement.

They are talking about each iron playing lengths, uncut shafts from the shaft manufacturers are longer.

The length listed is "club" length. Includes the clubhead.