Wedge shaft

Follow Thread

By Guy O

  • 9 Replies
  1. I have an older (SM5 ?) Vokey 54 degree that is in almost new condition. The problem is the shaft is bent. Does anyone know if the standard Dynamic Gold shaft installed in these wedges is taper or parallel tip? It’s been a while but I used to do quite a bit of my own club repair. Before I pull the shaft does anyone happen to know? Thanks in advance!

  2. Elson C

    Elson C

    Titleist Irons and wedges should all be .355 taper tipped.

  3. Joseph M

    Joseph M
    Saint John, New Brunswick

    Titleist only uses tapered tip shafts.
  4. No'l

    Palmdale, CA

    Here's an old thread I googled.. hope it helps.
  5. Thomas Y

    Thomas Y
    Wenham, MA

    It should be DG S200, taper tip. In my limited experience, you should order the shortest shaft (37.00") for the 9 iron and wedges with Titleist irons. Golf Works has DG S200 taper tip (0.355") shafts.
  6. Hey Guy, where are you located? I have an full set of original Vokey SM5 wedge shafts that are brand new, even the original grips are in new condition. I had them pulled and put in KBS shafts to match my AP2's. I'd be happy to send you the one for a 54 if you cover the shipping. Let me know what Zip Code your in and I'll check the cost.
  7. I think it is parallel tip. I reshafted my SM4 and it was parallel so I would imagine a SM5 would be too.

    Hope this helps.
  8. Jim W

    Jim W
    Vass, NC

    .355 taper
  9. Paul C

    Paul C
    Beech Mountain, NC

    Taper tip .355.
  10. Michael O, I’m in Central PA, near State College 16669. Thanks for the offer! I have a shaft but it’s parallel tip. I’d love to replace with your original! Let me know!

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up